Home » Automotive » Jeep » 2004 Jeep Grand Cherokee Limited Rear Absorber and Fascia Removal Installation Guide

2004 Jeep Grand Cherokee Limited Rear Absorber and Fascia Removal Installation Guide

July 19, 2011 Jeep

This removal and installation guide is provided for your 2002 Jeep Grand Cherokee Limited Edition. The guide consists of 5 pages and will covers about how to remove and install rear absorber for your 2002 Jeep grand cherokee limited and rear fascia removal and installation.

Rear Absorber Removal :
1. Remove rear fascia, refer to (Refer to REAR FASCIA ).
2. Remove rivets attaching absorber to rear crossmember.
3. Separate absorber from vehicle.

Rear Absorber Installation :
1. Position absorber on vehicle.
2. Install rivets attaching absorber to rear crossmember.
3. Install rear fascia, refer to (Refer to 13 – frames & bumpers/bumpers/front fascia installation ).

Rear Fascia Removal :
1. Raise and support vehicle.
2. Remove wheels.
3. Remove plastic push pins attaching fascia to fuel tank skid plate.
4. Remove plastic rivets attaching fascia to wheel liner.
5. Remove nuts attaching upper edge of fascia to quarter panel and wheel liner.
6. Remove nuts attaching upper edge of fascia to quarter panel and wheel liner.

Download Book :
2004 Jeep Grand Cherokee Limited Rear Absorber and Fascia Removal Installation Guide.pdf
Source : ww2.justanswer.com
Pages : 5

Leave a comment, and if you'd like your own picture to show up next to your comments, go get a gravatar!